Estimated delivery time may vary due to the following:
Item location.
Purchase quantities.
Your shipping address.
Selected shipping carrier.
Date of confirmed payment.
Seller's processing time on item customization.
Order status can be shown at your Buyer Center.
Oil Pressure Sender Switch 622-333 for FG Wilson Generators
Part Number: 622-333, 622333, 622-331, 622-137
Description:
Fit to all FG Wilson and Olympian genset models with 0-10 bar oil pressure gauges (12 and 24V) .
0-5 bar oil pressure sender/switch also available.
Specification:
Terminal G: Is the sender and wire "OP" should be connected to this tterminal - with the wire disconnected,
The terminal should read close to 10 ohms to ground with genset off.
Terminal WK: Is the switch and *wire "15" should be connected to this terminal - with the wire disconnected,
The terminal should read less than 1 ohm to ground with genset off.
* Wire "15" will not be connected on 2300 & 2800 electronic engines, since the engine's Electronic Control
Module will control the low oil pressure shutdown.